CyberData 011124 - 25 Watt PoE Power Injector

The new CyberData 011124 PoE power injector 802.3at is used with CyberData’s new V2 Paging Amplifier (Part # 011061) and V2 Loudspeaker Amplifiers (AC - Part #011095 and Wireless - Part #011096) to provide up to 25 watts of driving power. The CyberData 011124 Power Injector 802.3at eliminates the need for a PoE enabled hub. In a typical installation, the CyberData 011124 Power Injector is connected between a non-PoE hub and a CyberData paging device, providing inline power capability to an Ethernet Cat 5 cable.

CyberData 011124 - 25 Watt PoE Power Injector Specifications:

• Input: AC Input Voltage Range 90 to 264VAC
• Input: AC Input Voltage Rating 100 to 240VAC
• Input: AC Input Current 1.0A (RMS) and 90VAC at maximum load, .55A (RMS) and 240VAC at maximum load
• Input: AC Input Frequency 47 to 63Hz
• Output: Total Output Power 33.6W
• DC Offset: No Data degradation with DC imbalance 18mA
• Ripple and Regulation: 100mV maximum
• Efficiency: 78% (typical) at maximum load, and 120VAC 60Hz
• Transient O/P Voltage Protection: 60V maximum at switch on and off at any AC line phase
• Environmental: Temperature Operation -20 to +50°C Non-operation -20 to +65°C
• Humidity: Operation 5 to 90%
• EMC: FCC Part 15 Class B EN55022 Class B
• Isolation Test: Primary to Secondary: 4242 VDC for 1 minute 10mA, Primary to Field Ground: 2121VDC for 1 minute, Output to Field Ground: 2121VDC
• Immunity ESD: EN61000-4-2. Level 3 RS: EN61000-4-3. Level 2 EFT: EN61000-4-4. Level 2 Surge: EN61000-4-5. Level 3 CS: EN61000-4-6. Level 2 Voltage Dips EN61000-4-11 Harmonic: EN61000-3-2
• Insulation Resistance: Primary to Secondary: >10M OHM 500VDC Primary to Field Ground: >10M OHM 500VDC
• Feature: Over Voltage/Current, Short Circuit Protection Outputs equipped with short circuit protection and overload protection as per 802.3at specification The output can be shorted permanently without damage
• Indicators:
• Green LED 1: Input power “ON”
• Green LED 2: Valid IEEE802.3at load detected and connected “PoE PLUS”
• Green LED 3: Valid IEEE802.3af load detected and connected
• Input Connector: IEC320 3 pin
• Output Connection: +pins 3, 6 -pins 1, 2